Description
Dimensions
1.25″ (31,8 mm) ID
1.442″ OD
2″ Length
For Use With:
1.25″ ID Pin
In stock (can be backordered)
$22.49
This bushing is press-fit into the rear of your loader arms. In certain cases of excessive wear these can be welded in as well.
These bushings simply wear out over time causing a lot of play in your Bobcat®. Replacing these Bushings, when required, will help keep your machine operating like new.
$22.49
Dimensions | 2 × 1.44 in |
---|---|
Bobcat |
1.25″ (31,8 mm) ID
1.442″ OD
2″ Length
1.25″ ID Pin
Dimensions | 2 × 1.44 in |
---|---|
Bobcat |
Modify your existing equipment so it can be used on your skid steer or compact tractor.
Fits virtually any skid-steer or compact tractor manufactured after 1995 with Quick-Attach. Will fit some older models equipped with Quick Attach.
Quick attach plate is made of 5/16″ Grade 50 Steel
The Compression Spring fits between the Wedge and your Quick-Attach Handle. These springs put pressure on the wedges to hold your attachment/s securely to your machine.
The springs simply wear out over time… Replacing them can help your Bob-Tach operate like new again.
This Pivot Pin is used between the Lower Tilt Cylinder and your Bobcat® Bob-Tach.
This is a solid pivot pin – the pin does not have a grease zerk hole.