Description
Dimensions
1.25″ (31,8 mm) ID
1.442″ OD
2″ Length
For Use With:
1.25″ ID Pin
In stock (can be backordered)
$22.49
This bushing is press-fit into the rear of your loader arms. In certain cases of excessive wear these can be welded in as well.
These bushings simply wear out over time causing a lot of play in your Bobcat®. Replacing these Bushings, when required, will help keep your machine operating like new.
$22.49
Dimensions | 2 × 1.44 in |
---|---|
Bobcat |
1.25″ (31,8 mm) ID
1.442″ OD
2″ Length
1.25″ ID Pin
Dimensions | 2 × 1.44 in |
---|---|
Bobcat |
The Handle Spring keeps the handles in the ‘up’ position and keeps the handles tight. Replacing the Handle Springs will help make your Bob-Tach operate like new.
IMPORTANT NOTE: Bobcat uses two (2) different handle springs. One is long, one is short. This is the short one with only 3 coil windings.
Bobcat® Bob-Tach Handle Kit